Pelco C1607M (6/04) Getting Ready

6C1607M (6/04)
3. Using a Phillips-head screwdriver, remove the chassis cover:
WARNING: Make sure unit is turned off and you are wearing a properly grounded ESD wrist strap
before attempting to open the DX8000 chassis cover. Refer to the
Getting Ready section.
a. Remove the two top-most screws on the left and right side panels of the DX8000. Refer to Figure 4.
b. Remove the four silver screws fastening the cover to the rear of the unit. These screws are the ones closest to
the top of the unit. Refer to Figure 4.
c. Carefully remove the chassis cover by sliding it back and up. Set aside the cover. Figure 5 illustrates the
interior of the DX8000.
Figure 4. Removing Chassis Cover