Manuals / Brands / TV and Video / DVR / Pelco / TV and Video / DVR

Pelco C1607M (6/04) Disconnect the Data Cable and Power Wire

1 32

10 C1607M (6/04)

Disconnect the Data Cable and Power Wire

When removing the data cable and power wires, pull the connectors straight out. Do not rock connectors back and forth

or remove a connector by pulling it by its wires or cable.

1. Remove the IDE data cable from the hard drive, CD-RW drive, and motherboard:

a. Carefully pull the plastic tab of each cable connector away from the hard drive and CD-RW drive. Refer to

Figure 8.

b. Following the same procedure, remove the other end of each IDE cable from the drive interface connector on

the motherboard. Refer to Figure 8.

HARD DRIVE

IDE CONNECTOR

CD-RW

IDE CONNECTOR

MOTHERBOARD

IDE CONNECTOR 1b

Figure 8. Removing IDE Data Cables

Contents

Main Page Introduction PARTS LIST TOOLS NEEDED Getting Ready Tools Needed Parts List Page Page Preparing Unit for Drive Installation OPEN THE UNIT CHASSIS Getting Ready C1607M (6/04) 7 COMPONENT LAYOUT Figure 5. DX8000 Interior REAR OF DVR FRONT OF DVR Page Page Disconnect the Data Cable and Power Wire Page Remove the Drive Mount Baskets Install an Additional Drive PREPARE THE DRIVES Page Page SET THE MASTER / SLAVE JUMPERS Figure 15. Setting Drive Jumpers RECONNECT THE DATA AND POWER CABLES gray 1a black blue Page Page Page Page Page Preparing the New Drives to Store Data blue Page Page Page Page PRODUCT WARRANTY AND RETURN INFORMATIONPRODUCT WARRANTY AND RETURN INFORMATION If you are located within the continental U.S., Alaska, Hawaii or Puerto Rico, send goods to: