Pelco C1607M (6/04)

14 C1607M (6/04)

MOUNT THE ADDITIONAL DRIVE

1. Mount Hard Disk 2 adjacent to Hard Disk 1 in the drive basket closest to the CD-RW drive. Refer to Figure 12 below.

a. Make sure the drive is mounted in the basket so that access to the connectors is not blocked.

b. Attach the drive to the basket using the two screws that came with the upgrade kit.

c. Tighten the screws securely but do not over-tighten.

Figure 12. Inserting Drives into Basket

Contents

Main Page Introduction PARTS LIST TOOLS NEEDED Getting Ready Tools Needed Parts List Page Page Preparing Unit for Drive Installation OPEN THE UNIT CHASSIS Getting Ready C1607M (6/04) 7 COMPONENT LAYOUT Figure 5. DX8000 Interior REAR OF DVR FRONT OF DVR Page Page Disconnect the Data Cable and Power Wire Page Remove the Drive Mount Baskets Install an Additional Drive PREPARE THE DRIVES Page Page SET THE MASTER / SLAVE JUMPERS Figure 15. Setting Drive Jumpers RECONNECT THE DATA AND POWER CABLES gray 1a black blue Page Page Page Page Page Preparing the New Drives to Store Data blue Page Page Page Page PRODUCT WARRANTY AND RETURN INFORMATIONPRODUCT WARRANTY AND RETURN INFORMATION If you are located within the continental U.S., Alaska, Hawaii or Puerto Rico, send goods to: