Pelco C1607M (6/04)

C1607M (6/04) 15

2. Mount the drive basket back into the chassis:

a. Align the basket and press down firmly to ensure that it fits flush against the top of the chassis bracket. Refer

to Figure 13.

b. Secure the drive basket to the chassis using the four screws you set aside earlier.

Figure 13. Replacing Drive Basket

Contents

Main Page Introduction PARTS LIST TOOLS NEEDED Getting Ready Tools Needed Parts List Page Page Preparing Unit for Drive Installation OPEN THE UNIT CHASSIS Getting Ready C1607M (6/04) 7 COMPONENT LAYOUT Figure 5. DX8000 Interior REAR OF DVR FRONT OF DVR Page Page Disconnect the Data Cable and Power Wire Page Remove the Drive Mount Baskets Install an Additional Drive PREPARE THE DRIVES Page Page SET THE MASTER / SLAVE JUMPERS Figure 15. Setting Drive Jumpers RECONNECT THE DATA AND POWER CABLES gray 1a black blue Page Page Page Page Page Preparing the New Drives to Store Data blue Page Page Page Page PRODUCT WARRANTY AND RETURN INFORMATIONPRODUCT WARRANTY AND RETURN INFORMATION If you are located within the continental U.S., Alaska, Hawaii or Puerto Rico, send goods to: