Pelco C2403M-C, C2410M-H, C2491M-B, C2496M Installation

6 C2403M-C (10/05)

Installation

Follow the proceeding steps when feeding wire/cables through the base of the cover and back box:

1. Using the cover as a template, mark one

of the large hole positions onto the

mounting surface.

2. Cut out the hole in the mounting surface

for power and video wiring.

3. Pull video and power wires through the

hole in the cover.

4. Attach the cover to the mounting surface

(hardware not supplied). Use stainless

steel hardware when installing the

system outdoors.

5. Connect the video cable.

6. Connect the power wires.

•For 12 VDC, connect the 24 VAC/12

VDC (red) and GND (black) wires to

input power.

• For 24 VAC, connect the 24 VAC/12 VDC (red) and 24 VAC (blue) wires to input power.

7. Install the back box inside the cover. Rotate and position the back box so that the conduit plug

on the side of the box is located on the opposite side (180 degrees) from the notch on the side

of the cover. Use the supplied 8-32 x 0.375-inch screws and washers to secure the back box to

the cover.

NOTE:

For vandal-resistant installations, the conduit plug located on the side of the back box should

be hidden if it is not used. To hide the conduit plug rotate the back box so that the plug is located on

the opposite side (180 degrees) from the notch on the side of cover.

COVER

BACK BOX