Camera Adjustments
To perform the following camera adjustments, make sure to connect the camera and service connectors. You may have to remove the camera module from the back box.
Connect a monitor. Then turn on power to the camera and monitor. To use the service connector, refer to Service Connector on page 27.
To set the DIP switches, or to adjust the auto iris level (DN or CH) or the vertical phase (DW or CW), you will need a miniature trimpot adjustment tool with a
After you have adjusted the unit, reinstall the camera module into the back box, and then install the trim ring, bubble, and liner (if necessary).
VARIFOCAL LENS ZOOM AND FOCUS ADJUSTMENTS
NOTE: You will need a miniature Phillips or
To adjust the field of view:
1.Loosen the zoom locking screw (refer to Figure 8).
2.Turn the zoom adjustment ring clockwise or counterclockwise to select the field of view.
3.Tighten the zoom locking screw.
FOCUS
ZOOM
Figure 8. Location of Zoom and Focus Locking Screws
15 |
