Samsung RF24FSEDBSR Making Minor Adjustments To The Doors, Installing The Water Dispenser Line

Models: RF24FSEDBSR

1 40
Download 40 pages 7.76 Kb
Page 20
Image 20
How to adjust the level

the refrigerator if the left side of the refrigerator is lower than the right side.

How to adjust the level

1.Open the freezer drawer and remove the lower basket.

2.Insert a fl at-blade screwdriver (-) into the notch on the left control lever, and turn it counter- clockwise to level the refrigerator. (You turn the lever clockwise to lower the refrigerator and counterclockwise to raise it.)

flat-blade screwdriver (-) Control Lever

MAKING MINOR ADJUSTMENTS TO THE DOORS Both control levers must be touching the CAUTION fl oor to avoid possible personal injury or

property damage because of tipping.

If the right side is lower, perform the same procedure, but with the right control lever.

It is diffi cult to remove the cover leg front from the refrigerator, so we do not recommend making small adjustments with the control lever. Instead, refer to the next page for the best way to make minor adjustments to the doors.

MAKING MINOR ADJUSTMENTS TO THE DOORS

Remember, a leveled refrigerator is necessary for getting the doors perfectly even. If you need help, review the previous section on leveling the refrigerator.

Fixed part

Adjustment

part

20_ setting up

The left door is fi xed. To make minor door adjustments, adjust only the right door.

1.Pull out the fl ex door ( 1 ) to reveal the lower hinge ( 2 ).

2.Insert the supplied allen wrench (5 mm) ( 3 ) into the shaft ( 4 ) of the lower hinge.

3.Adjust the height by turning the hex wrench ( 3 ) clockwise ( DOWN ) or counter clockwise

( UP ).

 

 

When you turn the hex wrench counter-

 

clockwise (

), the door will move up.

 

2

 

 

3

3

 

4

 

1

 

 

INSTALLING THE WATER DISPENSER LINE

A water dispenser with a fi lter is one of the helpful features on your new refrigerator. To help promote better health, the water fi lter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that. In order for the ice maker to operate properly, a water pressure of 20~125 psi is required.

Under normal conditions, a 170 cc (5.75 oz.) cup can be fi lled in about 10 seconds.

If the refrigerator is installed in an area with low water pressure (below 20psi), you can install a booster pump to compensate for the low pressure.

After you have connected the water line, make sure the water storage tank inside the refrigerator is properly fi lled. To do this, press the water dispenser lever until the water runs from the water outlet.

Water line installation kits are include with unit. You can fi nd it in freezer drawer.

The new hose-sets supplied with the appliance are to be used and that old hose-sets should not be reused.

DA68-02916A (EN)-07.indd 20

2014. 5. 19. ￿￿ 2:06

Page 20
Image 20
Samsung RF24FSEDBSR Making Minor Adjustments To The Doors, Installing The Water Dispenser Line, How to adjust the level