Disassemble the refrigerator doors
Be careful not to drop and scratch the WARNING doors while removing them.
With the door opened
1.Remove the 3 screws holding down the TOP TABLE ( 1 ) and separate the connected wires.
1
2.Disconnect the two connectors ( 2 ) on the left side door. To remove the water coupler from the hinge, twist and pull it from the hinge. Remove the water line ( 3 ) while pressing the marked part ( 4 ) of the water line coupler.
If a red clip is on the coupler, you must CAUTION remove it before removing the tube.
2 |
Red Clip
(6 mm)
3
4
-Due to its design features, you can disassemble and
tilted at specifi c angles so that it is diffi cult to disassemble and
01 SETTING UP
Place the door, inside facing up, on a non- CAUTION scratching surface.
Door Middle Hinge | Auto Closing Hinge |
Check the direction
-If the Auto Closing Hinge is aligned to be vertical as shown in the fi gure, align it to be parallel by using the Door Middle Hinge. (Refer to No.5 for the disassembly of the Door Middle Hinge)
Do not use a fl at head screwdriver to align CAUTION the Auto close Hinge. It may get damaged.
Use the Door middle Hinge instead.
3.Pull and remove the hinge lever ( 5 ). Remove the ground screw ( 6 ) attached to the upper left door hinges with a philips screwdriver (+). Remove the upper left and right door hinges ( 7 ).
5. Remove the screw ( 8 ) attached to the |
lower left and right door hinges with a philips |
screwdriver (+). Remove the 2 hex head bolts |
5
6
( 9 ) attached to the lower left and right door |
hinges with an allen wrench (5 mm). Remove |
the lower left and right door hinges ( 10 ). |
7
10
8
9
4.Open the door (more than 90°), lift from the middle hinge and remove the door.
Allen wrench
setting up _17
2014. 5. 19. 2:06 |