REAR PANEL
The rear panel of the RCS Series rack mount power supply contains the following connectors.
Figure 3. Rear Panel Connectors
ì=Voltage Selector Switch: Determines the voltage of the unit. By default, the unit is equipped for 115 VAC line voltage.
îInput Fuse: Make sure the fuse matches the input voltage (115 VAC or 230 VAC). Refer to Table B for a list of fuse values. If you use 230 VAC, you must replace the main fuse with a spare fuse that is supplied with your unit, and then change the voltage selector switch. If 230 VAC is applied when the selector switch is set to 115 VAC, the fuse will blow.
Table B. Fuse Values for the RCS Series
| Input | Output | |
Models |
|
|
|
115 VAC | 230 VAC | 26 VAC | |
| Fuse Value* | Fuse Value | Fuse Value |
|
|
|
|
RCS8F5 | 1.6 A | 1 A | 3 A |
|
|
|
|
RCS8B5 | 1.6 A | 1 A | — |
|
|
|
|
RCS16F10 | 3 A | 1.6 A | 3A |
|
|
|
|
RCS16B10 | 3 A | 1.6 A | — |
|
|
|
|
RCS16F20 | 5 A | 3 A | 3 A |
|
|
|
|
RCS16B20 | 5 A | 3 A | — |
|
|
|
|
RCS32F20 | 5 A | 3 A | 3 A |
|
|
|
|
RCS32B20 | 5 A | 3 A | — |
|
|
|
|
*Shipped from factory fused for 115 VAC input.
ïPower: Attaches to the supplied power cord to provide power to the unit.
ñWiring Connectors for Individual Devices: A separate pin assignment is available for up to a maximum of 32 devices. Each connector has a pin labeled + (Positive) and – (Neutral).
10 |
