Connecting Devices to the Power Supply
Before you connect devices to the power supply, refer to Table A on page 7 and Table C on page 15 to determine the output wiring needed for each device.
To connect a device to the power supply:
1.Attach one output wire to the
2.To connect the wires to the power supply, strip back the wire insulation approximately 0.25 inch (0.64 cm).
3.If necessary, lift the terminal block locks into the up position.
Figure 8. Inserting Wires into Terminal Blocks
4.Insert the wire into the terminal, and then lower the lock. To remove the wires, lift and remove the lock.
5.Insert the terminal block along the back panel of the unit.
Figure 9. Inserting Terminal Blocks on the Back Panel
6.When you are finished with the wire connections, verify all of the connections as a safety precaution.
7.Connect the other end of the cord to a power source with the proper voltage, and then verify the correct voltage with a voltmeter.
14 |
