4. Secure the rear support rails in place by fastening four
Figure 7. Securing Rear Support Rails to the Mounting Rails
5.If necessary, change the voltage from 115 VAC to 230 VAC by rotating the selector switch located next to the power connector (refer to Rear Panel on page 10).
WARNING: Pelco shall not be liable for any damages resulting from incorrect wiring or improper loading of an RCS Series rack mount power supply.
6.Attach the power cord (supplied) to the power connector on the rear panel of the unit. If you changed the voltage in Step 5, above, connect a higher-voltage power cord (not supplied).
WARNING: Units are equipped for 115 VAC line voltage at the factory. For 230 VAC, you must change the voltage selector switch and main fuse. If 230 VAC is applied with the selector switch set to 115 VAC, the fuse will blow.
| 13 |
