Tech Tips
Helpful Tips for Pelco Products
e.Click Back.
f.Make sure to delete each raid array.
6.Add Raid Array. (See Figure 10)
a.Select Add Array tab.
b.Type name next to array name. Raid1 is a sample name.
c.Select all disks except Pool Spare.
d.Click Create Raid Set button.
e.Click Back.
Figure 10
7.Add Volumes Note: The first volume is automatically set up after the Raid array is created. More Volumes need to be created based on the HDs of SATABoy (three volumes for 14 HDs SATABoy and two volumes for 8HDs SATABoy). The volume size limit is 1.7 TB.
a.Select the CONFIGURE VOLUMES option under the main menu.
b.Select ADD VOLUME.
c.Change the unit by placing a dot next to % and click Change Units.
d.Click Back.
e.Type the name next to Enter the name for the new volume. Volume #2 is a sample name
f.Type 100 next to Enter the size of the new volume in % of array capacity.
g.Place a check mark next to Limit volume size to less than 2TB.
h.Select LUN0 next to Select LUN for new Volume on port 0. (Select LUN1 for Volume 2 and so on)
World Headquarters
3500 Pelco Way, Clovis, California 93612 USA
USA & Canada Tel:
International Tel:
Pelco and the Pelco logo are registered trademarks of Pelco, Inc. Information subject to change without notice.
©Copyright 2008, Pelco, Inc. All rights reserved.
Page 15 of 21 |