Pelco DX8100-ISCI INSTALLING THE DX8100 SCSI CARD

Tech

Tips

Helpful Tips for Pelco Products

World Headquarters

3500 Pelco Way, Clovis, California 93612 USA

USA & Canada Tel: 800/289-9100 Fax: 800/289-9150

International Tel: 1-559/292-1981 Fax: 1-559/348-1120

www.pelco.com

Pelco and the Pelco logo are registered trademarks of Pelco, Inc.

Information subject to change without notice.

Page 6 of 21 DX8100-ISCI_SCSI_CARD_SATABoy.fm

d. Reconnect the 7-wire TV/Audio cable.

e. Reconnect the 2-wire audio cable.

Figure 8. Moving Main Capture Card

INSTALLING THE DX8100 SCSI CARD

The DX8100-ISCI SCSI card is shipped separately. The SCSI card is installed in the PCI slot 2 on the

motherboard.

To Install the DX8100-ISCI SCSI card:

1. Verify that the main Capture Card is installed in slot 3. For information about moving the main

Capture Card from slot 2 to slot 3, refer to Moving the Main Capture Card to Slot 3 on page 5.

2. To install the SCSI card into slot 2:

a. Firmly seat the DX8100-ISCI SCSI card in the PCI connector for slot 2.

b. Secure the DX8100-ISCI SCSI card bracket with the screw removed from slot 3.

c. Reconnect the 32-pin ribbon cable to the first 32-pin connector (on the main Capture Card) in

slot 3.

3. Replace the rear cross-brace.

Note: Connect the 68-pin high density cable to the bottom port of the SCSI card. Connect the other

side to Host 0 on the bottom port of the SATABoy.