Pelco DX8100-ISCI

Tech

Tips

Helpful Tips for Pelco Products

World Headquarters

3500 Pelco Way, Clovis, California 93612 USA

USA & Canada Tel: 800/289-9100 Fax: 800/289-9150

International Tel: 1-559/292-1981 Fax: 1-559/348-1120

www.pelco.com

Pelco and the Pelco logo are registered trademarks of Pelco, Inc.

Information subject to change without notice.

Page 2 of 21 DX8100-ISCI_SCSI_CARD_SATABoy.fm

Figure 2. Removing Power Cord from Wall

1. Remove the power cord from the back of the DX8100.

2. Ensure that the DX8100 Series DVR and all of its components are protected against ESD. Before

handling any electronic components, you should take steps to ground yourself properly so that any

built-up static electric charges are dissipated away from the unit. The most effective method for

combating ESD is to use a properly grounded wrist strap. Refer to Figure 4.

Figure 3. Removing Power Cord from DX8100

NOTE: If you do not have access to a grounded wrist strap, you can discharge any built-up static by

periodically touching an unpainted section of the chassis.

Figure 4. ESD Protection