
Chapter 2 Cabling the CSS
Connecting the Power Cord
3.Using a
connectors (labeled from left to right, , respectively).
Warning Before installing a wire, ensure that the polarity of the DC connections is correct. Reversed polarity can cause damage to the DC power supply and can create a dangerous shock hazard.
Do not consolidate the end of a conductor by soft soldering prior to installation.
4.Install the wires into the appropriate connector. Make sure that the
Warning When installing the wires, always connect the ground wire first. When disconnecting the wires, always disconnect the ground wire last.
5.Tighten the captive screws to 5 to 7
6.Repeat steps 1 through 5 for each power supply.
7.Install the three sets of wires to the DC power source.
For the proper power cable wiring between the CSS 11506 and DC power source, see Table
Table 2-10 CSS 11506 to DC Power Source Cabling
CSS 11506 | DC Power Source | ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| (Ground) |
|
|
|
|
| (Ground) |
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
+ |
|
|
|
| + |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
– | – | ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
Warning The proper wiring sequence is ground to ground, positive to positive, and negative to negative. The ground wire should always be connected first and disconnected last.
|
| Cisco 11500 Series Content Services Switch Hardware Installation Guide |
|
|
|
|
| ||
|
|
| ||
|
|
|