Cisco Systems 11500 Series manual To install a module, 1-25

Chapter 1 Unpacking and Installing the CSS

Installing a CSS Module

To install a module:

1.Properly ground yourself prior to handling the module. For example, wear the anti-static wrist strap (included in the accessory kit) and stick the copper-tape end of the strap to an unpainted metal surface on the chassis. Make sure that the wrist strap makes good contact with your skin.

2.If necessary, power down the CSS.

3.Locate an open slot in the chassis for the module. See Table 1-3to identify possible slots for the module. If necessary, use a #1 Phillips screwdriver to remove a blank panel from the chassis to expose a slot for the module.

4.Insert the module into the board guides at the left and right of the slot. Make sure that the ejectors are fully extended outward. Slide the module into the chassis by pressing firmly at the left and right of the faceplate as shown in Figure 1-8.

Figure 1-8 Installing a Module into a CSS Chassis

1														CISCO			11500
														C O N	T E N T			SERIES
																S E R
																	V I C E S	S W I
10	11																	T C H
		12	13	14
					15
1	2	3	4	5	6
						7	8
								9	10
										11	12
												13
													14	15
SS5-10M-16FE
2							LINK	DPLX						rnet
							LINK							the
								DPLX						tE
														Fas
														16

59542

1

Spring-loaded screw (one on each side)

2

Ejector (one on each side), extend outward during insertion

5.Close both ejectors simultaneously to seat the module connector into the backplane.

6.Using a Phillips screwdriver, tighten the spring-loaded screws on the front of the module faceplate.

7.Reboot the chassis to activate the module.

	Cisco 11500 Series Content Services Switch Hardware Installation Guide
78-13884-03		1-25