Cisco Systems 11500 Series manual Terminal block -, +, Power switch

Chapter 2 Cabling the CSS

Connecting the Power Cord

Warning Only a DC power source that is isolated from AC mains with reinforced insulation, and that complies with the other safety extra-low voltage (SELV) requirements in UL1950, CSA 950 3rd Edition, EN 60950, and IEC950, can be connected to a Cisco 11503 system. This requirement ensures that in a catastrophic power source fault condition, hazardous voltages are not present on power terminals and connectors.

To connect the CSS 11503 DC power supply to a power source:

1.At the rear of the chassis, ensure that the CSS power switch is in the O (off) position.

2.Locate the DC terminal block on the rear of the chassis as shown in Figure 2-13.

Figure 2-13 Location of the CSS 11503 DC Power Supply Connectors

1

	-
		48/-60V
	9.	0A,430VA
				59544
1	2
Terminal block (–, +, and			)	2 Power switch

	Cisco 11500 Series Content Services Switch Hardware Installation Guide
78-13884-03		2-29