
Chapter 3 Booting and Configuring the CSS
Using the Configuration Script
Using the Configuration Script
The CSS initiates the configuration script automatically when you log in and it does not detect an existing
•IP address and subnet mask for circuit VLAN1 (all interfaces are assigned to VLAN1 by default)
•IP address for the default gateway
•IP addresses for the servers
•Virtual IP address (VIP) for the content rule
The configuration script allows you to create services, owners, and content rules based on your entries and then enables you to:
•Configure Layer 3 load balancing
•Configure Layer 5 load balancing
•Configure Proxy cache
•Configure Transparent cache
•Exit from the script and save the information you entered to the
Note For information on services, owners, and content rules, refer to the Cisco Content Services Switch Basic Configuration Guide.
To accept the script default values, press the Enter key at the prompts. To quit the script, enter q at any prompt.
You may also initiate the configuration script manually by entering the script play setup command.
To clear an existing
The following pages show you the entire configuration script including:
•Bold text to indicate where you enter information
•Explanations to help you use the script
| Cisco 11500 Series Content Services Switch Hardware Installation Guide |