Kramer Electronics Configuring the FC-8 Wi-Fi - RS-232 Bridge, Parameter, Possible Values

Configuring the FC-8 Wi-Fi - RS-232 Bridge

Table 3: FC-8 Serial Net Configuration Parameters

Parameter	Possible Values	Notes
MAC Address		Ethernet hardware address (read-only)
Bootblock Version		For technical use (read-only)
Serial Number		Factory serial number of the device (read-
		only)
Web Server Status Message	Must be I/OK	(read-only)
Firmware Version	Must end with b17 or above	(read-only)
Hardware Version		For technical use (read-only)
Active IP Address	192.168.3.2 (Default)	Active IP address of the FC-8
Subnet Address	255.255.255.0 (Default)
IP Gateway	0.0.0.0 (Default)
Wireless LAN SSID	Alpha-numeric	Network name (SSID)
	Kramer-FC8 (Default)
	An ad-hoc network must
	begin with the character “!”
IP Registration Host Server	nnn.nnn.nnn.nnn:ppp	The Registration Host Server Name is used
Name	Where:	to locate and establish a connection after
	nnn.nnn.nnn.nnn =	FC-8 establishes an Internet session
	a server name or IP address	connection as a result of an explicit
		command or as a result of automated
	ppp = 0..65535	Internet session establishment procedures.
		The dynamically assigned IP address is sent
	If Registration Host Server	to the server in ASCII form, after which the
		socket is closed. See Socket IP Registration.
	Name is empty, no IP	It is assumed that the host server is
	registration server name is	"listening" on port number.
	defined.	FC-8registers itself by opening a socket to a
	192.168.3.1 (Default)	registration server and sending its ID
		information and current IP address. When
		the Registration Host Server Name
		parameter contains a value, the FC-8
		establishes a socket to the server defined in
		Registration Host Server Name during the
		registration procedure. When a socket is
		established, FC-8transmits its ID information
		and current IP address in the following
		format:
		FC-8-<D/L/S> S/N:<RP5> version: <RP1>
		HN:<HSTN> IP:<IPA or RRRL> Port:<LPRT
		or 80 or 0>”
		The registration socket is then closed.
SerialNet Listening Port	0 to 64000
	10000 (Default)
Socket Type	0 – TCP (Default)
	1 – UDP
Host Server & Port	nnn.nnn.nnn.nnn:ppp	To configure the FC-8as an active station,
		see section 6￿ .4.
Security Type	0 ± N	No security
	1 ± WEP64
	2 ± WEP128
	3 ± WPA
	4 ± WPA2
10		KRAMER: SIMPLE CREATIVE TECHNOLOGY