Compaq 1850R Installing a Processor and Processor Power Module

3-4 Installing Hardware Options

Writer: Michele Wray Project: Compaq ProLiant 1850R Setup and Installation Guide Comments: 333172- 002

File Name: D-CH03.DOC Last Saved On: 1/29/99 8:15 AM

COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED

6. Loosen the three thumbscrews on the front of the unit which sec ure the

server cover.

7. Slide the server cover toward the rear of the unit a bout 1 inch (2.5 cm),

then remove the cover.

Figure 3-2. Removing the server cover

Installing a Processor and ProcessorPower Module

To install a processor on the System Board, refer to the label inside the server

cover, refer to the processor option kit, or follow t he procedures below. This

procedure can be used to install a processor and Processor Power M odule in

either socket 1 or 2. The figure below illustrates the processor sockets and the

Processor Power Module slots.

Contents

Main Notice Compaq ProLiant 1850R Setup and Installation Guide Contents About This Guide Chapter 1 Compaq ProLiant 1850R Features Chapter 2 Server Installation Overview Chapter 3 Installing Hardware Options Chapter 4 Cabling Guidelines Chapter 5 Server Configuration and Utilities Chapter 6 Integrated Management Log Appendix A Regulatory Compliance Notices Page Appendix G Updating LAN Drivers Index Page About This Guide Text Conventions Symbols in Text ! Symbols on Equipment Rack Stability ! Getting Help Compaq Web Site Telephone Numbers Chapter 1 Compaq ProLiant 1850R Features ProLiant 1850R Page ProLiant 1850R Front View Page 1-5 Table 1-2 Compaq ProLiant 1850R Wide Ultra2 Front Components Thumbscrew Identification Table 1-3 Front Bezel Thumbscrew Locations 1-7 ProLiant 1850R Rear Components The following figure shows the components on the rear of the ser ver. Table 1-4 Rear Panel Components 1-8 Compaq ProLiant 1850R Features Locating ProLiant 1850R Server Internal Components Inside View of the ProLiant 1850R Server Table 1-5 ProLiant 1850R Internal Components Industry Support Standard Features Processors and Processor Power Modules Page Disk Controller Integrated Network Controller Mass Storage Wide Ultra SCSI-3 Models Table 1-6 Description of ProLiant 1850R Media Bays Page Table 1-7 Description of ProLiant 1850R Wide Ultra2 Media Bays Standard Interfaces Video ROM Hot Plug Power Supply Warranty Server Management and Configuration Default Configuration Compaq SmartStart Server Management Fault Tolerance Compaq Insight Manager Compaq System Configuration Utility Automatic Server Recovery-2 (ASR-2) Compaq Integrated Remote Console Front Panel Status LEDs Description Hot-Plug Power Supply LED RJ-45 LED Indicators Security Features Diagnostics Pre-Failure Warranty Insight Manager Alert Chapter 2 Server Installation Overview Page Server Warnings and Precautions Page Temperature Requirements Table 2-1 Rack Internal Temperature Maximums Page Installation Sequence Page Page Bag of screws Installing Expansion Boards and Other Major Hardware Options Preparing the Rack Mounting Brackets and Slide Rail Assemblies Slide Rail Assembly Components Attaching the Outer Bracket Rail to the Rack Mounting Bracket Page Page Page Page Page Attaching the Rack Mounting Bracket and Slide Assembly to the Rack Measuring with the Template Inserting Cage Nuts in the Rack Frame Attaching the Rack Mounting Bracket Assembly to the Rack Page Page Attaching Server Rails to the Server Attaching the Server Bracket to the Server Loading the Rack Server Page Attaching the Cable Management Arm Page Connecting the Power Cord and Peripheral Devices 2-31 Table 2-2 Rear Panel Connectors/LED Page Powering Up the Server Configuring the Server with Compaq SmartStart Page Using the Power Switch Using Diagnostics Tools Registering Your Server Routine Maintenance Optional Installation Service Chapter 3 Installing Hardware Options Accessing Non Hot-Plug Areas Accessing Processors, Memory Sockets, and System Board Page Installing a Processor and Processor Power Module Table 3-1 Processor and Processor Power Module slot locations Page Installing a Processor Power Module Adding Memory to the ProLiant 1850R Server Table 3-2 DIMM Option Kit Part Numbers Table 3-3 DIMM Socket Identification Maximum Memory Configuration Installing DIMMs Identifying Expansion Slots Page Installing an Expansion Board Page Removing Expansion Board Shipping Bracket Replacing the Riser Board and Riser Board Brace Replacing the Riser Board and Riser Board Brace Page Installing Removable Media Devices General Installation Guidelines SCSI ID Settings for Compaq Hard Drives Table 3-4 SCSI ID Settings Installing ProLiant 1850R Mass Storage Devices Page Replacing the 1.44-MB Diskette Drive (Floppy Drive) Removing the 1.44-MB Diskette Drive (floppy drive) Page Installing the 1.44-MB Diskette Drive (Floppy Drive) Enabling the Power Switch Security Feature To enable the power switch security feature: Page Replacing the CD-ROM Drive Removing the CD-ROM Drive Installing the CD-ROM Drive Attaching Mass Storage Devices Installing External Storage Devices Installing a 3.5-Inch Drive into a 5.25-Inch Drive Bay Page Page Installing a Half-Height Device Page Installing a Full-Height Device (DLT Tape Drive) Page Accessing the Hot-Plug Areas Installing Hot-Plug Wide Ultra SCSI-3 Drives Installing Hot-Plug Wide Ultra2 SCSI Drives SCSI ID Numbers for Wide Ultra SCSI-3 Models Page Installing a Hot-Plug Redundant Power Supply Page Page Page Chapter 4 Cabling Guidelines Connecting the Power Cord and Peripheral Devices 4-2 Cabling Guidelines Rear Panel Connectors The illustration below shows the connectors and switches for the ProLiant 1850R server. Table 4-1 Rear Panel Connectors Internal Connectors Table 4-2 Important Connectors Cabling the Servers Rear Panel Cables Page Additional Mass Storage Devices Guidelines Contents Table 4-3 ProLiant 1850R Server Cables and Server Cable Kit Contents SCSI Cable Connectors SCSI Cabling Guidelines Determining the Cables you Need Internal SCSI Cabling Guide For Compaq ProLiant 1850R Servers 4-13 Internal Cabling Table 4-4 Internal Cabling for the Compaq ProLiant 1850R 4-14 Cabling Guidelines Internal Cabling for the Compaq ProLiant 1850R Continued 4-15 External Cabling for Primary Storage Only Table 4-5 External Cabling for Primary Storage Only 4-16 Cabling Guidelines External Cabling for Secondary Storage Table 4-6 External Cabling for Secondary Storage ProLiant 1850R Cabling Examples Connecting an Array Controller to the Hot-Plug Drive Cage Backplane Board Page ProLiant 1850R Maximum External Storage Cabling Connecting Three Array Controllers For Maximum External Storage Capability Chapter 5 Server Configuration and Utilities Compaq System Configuration Utility Resolving Resource Conflicts Starting the System Configuration Utility System Configuration Utility Main Menu System Configuration Menu Configuring Hardware 1. Important System Configuration Information 2. Add or Remove Boards 3. View or Edit Details 4. Examine Required Switches 5. Save and Exit Drive Array Configuration Setting Power-On Defaults System Partition Creating a New System Partition Verifying the System Partition Upgrading the System Partition Configuration Backup Configuration History Files Table 5-1 System Configuration History Log Files Boards Automatically SMP Operating System Support Loading Compaq Device Drivers Novell Device Drivers from Compaq Manual Installation Microsoft Windows NT Device Drivers from Compaq Manual Installation SCO OpenServer and SCO UnixWare Device Drivers from Compaq Special Considerations IBM OS/2 Device Drivers from Compaq Manual installation Retail Installation SunSolaris Device Drivers from Compaq Banyan Vines Device Drivers from Compaq Manual installation Diagnostics and Other Utilities Controller Naming Conventions Table 5-2 Controller Driver Naming Conventions Page Chapter 6 Integrated Management Log Multiple Ways of Viewing the Log Compaq Insight Manager Viewing the Event List Printing the Event List Compaq Survey Utility 6-4 Compaq Integrated Management Log List of Events Table 6-1 Event Messages 6-5 Event Messages Appendix A Regulatory Compliance Notices Federal Communications Commission Notice Modifications Cables Declaration of Conformity for products marked with the FCC logo - United States only Canadian Notice Japanese Notice Avis Canadien European Union Notice Taiwan Notice Laser Devices Laser Safety Warnings Compliance with CDRH Regulations Compliance with International Regulations Laser Product Label Laser Information Battery Replacement Notice Appendix B Electrostatic Discharge Grounding Methods Page Appendix C Power Cord Set Requirements General Requirements Country-Specific Requirements Table C-1 Power Cord Set Requirements - By Country Appendix D Installing a New Battery System Board Battery Replacement Installing the System Board Battery Page Page Appendix E Switches and Jumpers Setting System Board Switches System Configuration Switch Settings (S1 Settings) E-3 Processor Switch Settings The following table defines the function for each switch setting on SW1. Table E-2 Processor Switch Settings NIC Operating Mode SCSI Device Jumper Settings Table E-3 SCSI Device Jumper ID Settings Page F-1 Appendix F Specifications and Connector Interfaces ProLiant 1850R Specifications Table 1-1 ProLiant 1850R Specifications Connector Interfaces Appendix G Updating LAN Drivers Introduction Operating Systems Requiring Special LAN Driver Installation Installing NetWare Lan Drivers For Novell Products (NSSD) version 3.22A diskettes :\cpqsupsw\nssd\network LAN Driver Update Procedure intraNetWare for Small Business from Compaq Setup intraNetWare for Small Business from Compaq Page LAN Driver Update Procedure NetWare for Small Business 4.11 Setup NetWare for Small Business 4.11 LAN Driver Update Procedure For NetWare 3.2 Installing Windows NT 4.0 LAN Drivers For Windows NT 4.0 (NTSSD) version 2.08 diskettes LAN Driver Installation Procedure for Window NT 4.0 Installing IBM OS/2 LAN Drivers LAN Driver update procedure for IBM Operating Systems Installing Banyan VINES LAN Driver LAN Driver update procedure for Banyan Vines versions 6.X, 7.X and 8.x. Page Installing SunSoft Solaris 2.5.1, 2.6, and Later Versions (Intel Platforms) LAN Drivers Index Symbols Numbers A B C D E F G H I J K L M N O P R Page S Page T U V W