Pelco DX8UP-512MBRAM installation manual Introduction, Getting Ready, Parts List, Tools Needed

Introduction

The following instructions serve as a guide for the installation of the DX8UP-512MBRAM memory expansion module.

PARTS LIST

Qty Description

1512 MB double data rate (DDR) dual in-line memory module (DIMM)

1Adhesive-backed upgrade part label

Figure 1. 512 MB DIMM Module

TOOLS NEEDED

1Phillips-head screwdriver #1 (nonmagnetic)

1Properly grounded ESD wrist strap and mat

4Small containers for storing screws (optional)

Getting Ready

1.Familiarize yourself with the instructions throughout this manual.

2.Check that you have all the necessary parts and tools. Refer to the Parts List and Tools Needed sections.

3.Shut down the DX8000 Series DVR unit. Refer to DX8000 Installation Manual or Operations and Programming Manual for instructions on shutting down your unit.

4.Unplug the power cord from the wall socket and then from the rear of the DVR.

WARNING: For safety reasons, you must remove the power cord because current continues to flow through the DX8000 even when

the unit is off. Remove the power cord from the wall socket first and then from the rear of the DVR. It is critical that the unit be unplugged for your safety.

Figure 2. Removing Power Cord from Wall

2 C2612M-A (6/06)