Pelco IP3701H-2 manual Wiring Tables, CAT5 CABLE, Vac And Bnc Connections Optional, Function

Wiring Tables

CAT5 CABLE

Connect a Cat5 cable to the RJ-45 network connector. The 8-pin connector includes video and PoE for the camera. PoE (IEEE 802.3af) injects power over the same cabling that carries the network data, eliminating the need for a separate power supply. This simplifies the installation and operation of the camera without any degradation of network performance.

Refer to Table B for pin descriptions.

Table B. Pin Descriptions

Pin	Function
1	TX+
2	TX-	1	8	8
3	RX+				1
				7
				8
4	PoE 1-2				6
					4
					5
					3
					2
5	PoE 1-2				1
6	RX-
7	PoE 3-4

8PoE 3-4

24 VAC AND BNC CONNECTIONS (OPTIONAL)

If PoE is not used, the camera includes a 24 VAC power connector. Connect the power cable to the 2-pin power connector on the back of the camera using the terminal block connector (provided). Refer to Table C for the recommend wire gauge and wiring distances.

The power supply connector is shown in Figure 6. Use only a Class 2 isolated power supply. Refer to Specifications on page 21 for power consumption.

CLASS 2

ISOLATED

POWER

SUPPLY

24 VAC

Figure 6. Power Supply Connections

C2941M-C (6/08) 11