Pelco IP3701H-2 manual Problem, Possible Cause, Suggested Remedy, Image too light

Problem	Possible Cause	Suggested Remedy
Image too light	Installation error	• Verify DIP switch settings.
		• Use a service connector to verify camera
		operation. Connect one end of the service
		connector to the BNC service connector on the
		camera. Connect the other end of the service
		connector to a monitor.
		• Replace camera with a working camera. If the new
		camera does not work, contact Pelco Product
		Support at 1-559-292-1981 or 1-800-289-9100.
Image only	Color level setting	• Verify DIP switch settings.
displays in		• Use a service connector to verify camera
black-white		operation. Connect one end of the service
		connector to the BNC service connector on the
		camera. Connect the other end of the service
		connector to a monitor.
		• Replace camera with a working camera. If the new
		camera does not work, contact Pelco Product
		Support at 1-559-292-1981 or 1-800-289-9100.
Image flickering	Flickerless setting	• Verify DIP switch settings.
		• Verify power supply specifications.
		• Replace camera with a working camera. If the new
		camera does not work, contact Pelco Product
		Support at 1-559-292-1981 or 1-800-289-9100.
Unable to sync	Network connectivity issues	• Disconnect the power cable (either PoE or 24 VAC)
to an Endura®		and then reconnect it to the camera. Power is
system manager		indicated by the LED. The LED will flash (green)
or NTP server		five times per second for approximately two
after changing		minutes if the camera has power.
networks		• Reset the camera’s factory defaults. Refer to Reset
		Button on page 9.

20 C2941M-C (6/08)