Pelco IS210 manual Removing the Conduit Cover

CONDUIT COVER

HEX HEAD INSET

SCREW

1/16-INCH HEX HEAD WRENCH

Figure 7. Removing the Conduit Cover

6.Install a 0.75-inch (1.91 cm) conduit connector in the conduit opening. Line up the mounting holes in the base with the mounting holes of the mounting plate. Attach the base to the mounting plate with the three 8-32 x 0.375-inch screws and washers previously removed.

7.Attach the base to the conduit and then connect the power input wires to the power wires of the IS210 Camclosure. Refer to the following to connect the power wires:

Table B. Power Input

Voltage	Red Wire	Black Wire
12 VDC	+	Ground
24 VAC	~	~

8.Connect the video cable/wires:

•BNC: Connect the BNC connector from the unit to a mating BNC connector.

•UTP: Connect the blue wire to Video +; connect the gray wire to Video -.

C3428M-A (1/08) 11