Installation
PREPARE MOUNTING SURFACE
1.Remove the cover of the IS210. Use the screwdriver bit (supplied) to loosen the three tamperproof screws, and then lift the cover from the base.
2.Remove the camera assembly from the base by removing the Phillips screws on each side of the camera assembly (refer to Figure 2).
CAMERA ASSEMBLY
PHILLIPS
SCREW
Figure 2. Removing Camera Module
3.Remove the base from the mounting plate by removing the three
4.Select a fixed or adjustable mounting pattern (refer to Figure 3 and Figure 4 on page 8). Using the mounting plate as a template, mark the wire feedthrough and fastener hole positions on the mounting surface. Prepare the holes for the installation.
7 |
