Pelco IS210 manual SW1-8 Day/Night Operation DW models only

SW1-8: Day/Night Operation (DW models only)

NOTE: On CW models, SW1-8 is unused and does not affect camera operation.

DW model cameras regularly check the brightness level of the field of view to determine when to switch between day (color) and night (black-white) operation. Use SW1-8 to set the general light levels at which the camera will automatically switch.

Set SW1-8 to ON (dark) to use standard thresholds to switch between color and black-white operation. This is the default setting.

Set SW1-8 to OFF (dusk) to use higher light thresholds to switch between color and black-white operation.

Actual brightness threshold levels are affected by camera angle, amount of zoom, field of view, lens, and type of lighting. The switching process lasts from 7 to 10 seconds.

Figure 13 and Table D show how the camera switches between color and black-white operation for each setting.

B-WCOLOR

COLOR

MODE

B-WCOLOR

MODEMODE

MODEMODE

7.0 lux

FALLING LIGHT LEVEL

B-WCOLOR

MODEMODE

RISING LIGHT LEVEL

FALLING LIGHT LEVEL

4.0 lux

MODE

RISING LIGHT LEVEL

3.0 lux

B-W

1.0 lux

DARK

DUSK

Figure 13. DW Models Threshold Switching Levels

Table D. DW Models Switching Thresholds

	Dark (ON)	Dusk (OFF)
Color to B-W	1.0 lux	4.0 lux
B-W to Color	3.0 lux	7.0 lux

NOTE: These switching thresholds are approximate and were measured using a 3.0 mm to 9.5 mm lens at f/1.0. Use the thresholds in Table D as a guide when installing the unit.

C3428M-A (1/08) 19