6.Attach the back box to the mounting surface:
•If you have access behind the ceiling/wall (refer to Figure 6 on page 13):
(1)Place the adapter plate on the inside of the ceiling/wall.
(2)Attach the back box to the ceiling/wall with two
•If you do not have access behind the ceiling/wall access, use
BACK
BOX
CEILING/
WALL
(NOT SUPPLIED) |
Figure 8. In-Ceiling Installation to a Fixed Ceiling/Wall
SURFACE INSTALLATION: 4S STANDARD ELECTRICAL BOX
1.Attach the adapter plate (supplied) to the 4S box with two
2.Pull the video and power wires through the adapter plate.
3.Connect the video cable and wires:
•BNC: Connect the BNC connector from the unit to a mating BNC connector.
•UTP: Connect the blue wire to Video +; connect the gray wire to Video
4.Connect the power wires (refer to Table D).
Table D. Power Input: Surface, 4S Standard Electrical Box Installation
Voltage | Red Wire | Black Wire |
|
|
|
12 VDC | + | Ground |
|
|
|
24 VAC | ~ | ~ |
|
|
|
AC operation only: If you are wiring more than one Camclosure to the same transformer, connect one side of the transformer to the red wire on all units; connect the other side of the transformer to the black wire on all units.
NOTE: Failure to connect all AC powered units the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.
15 |
