Pelco KBD300V Sequence status, and time/date are shown on the monitor, Next to resume, Shows O

	Table D. Keyboard Functions (continued)
Function		Procedure
Sequence*	Sequence steps through all 16 cameras. Camera number, camera title,
	sequence status, and time/date are shown on the monitor.
	Press PREV 4A to step back one camera. Hold for two seconds for a back-
	ward sequence. Monitor shows B. Press during sequence to speed up. Press
	during a forward sequence to reverse.
	Press NEXT 4B to step forward one camera. Hold for two seconds for a for-
	ward sequence. Monitor shows F. Press during sequence to speed up. Press
	during a backward sequence to go forward.
	Press HOLD 4C to hold a sequence. Monitor shows H. Press PREV or
	NEXT to resume.
	Manually select a camera or press CAM 14 to turn off a sequence. Monitor
	shows O.
Macro Sequence*	Enter 1 or 2 15 and press MACRO 8 to start a group camera sequence. Moni-
	tor shows M. Refer to the CM6700 manual for macro/sequence programming.
Multiplexer	Press SHIFT 2 . Shift key LED 3 lights. The function keys F1 through F5
Displays*	can now be used to display the images from multiple cameras on the monitor.
	F1: Zoom
	F2: PIP display
	F3: Quad display
	F4: 9-screen display
	F5: 16-screen display
Auxiliaries/	F1 Ð F3	5 control only the auxiliaries built into the CM6700 SCU.
Relays	These outputs can be programmed for momentary, keyed, latched, or alarm
	operation. Refer to the CM6700 manual for programming instructions.
	F1: Activate/deactivate auxiliary 1 relay.*
	F2: Activate/deactivate switcher auxiliary 2 TTL output.*
	F3: Activate/deactivate switcher auxiliary 3 TTL output.*
	F4 and F5 control the auxiliaries in receivers.
	Enter the auxiliary number and press F4 to turn on. Hold, then release for
	momentary functions.
	Enter the auxiliary number and press F5 to turn off.
	In Direct Mode, F1- F3 5 have no function. LED 1 shows auxiliary num-
	ber for two seconds after F4 or F5 5 is pressed.
Acknowledge	Press ACK 16 to acknowledge an alarm. Refer to the CM6700 manual for
Alarm*	further information on alarms.
Program	To program the CM6700 switcher, press PGM 7 .
(CM6700)	Follow the programming procedure in the CM6700 manual. LED display 1
	shows P in program mode. Press ACK 16 to exit.
LED	LED 1	shows monitor number (in CM6700 Mode) or camera/receiver number
	(in Direct Mode) and P (in Program Mode).
Firmware Version	LED 1	flashes for a few seconds to show firmware version on power up
	(not functional on versions prior to 4.0).
Clear	Press CLEAR 13 to cancel a number that has been entered.

*This function is not used in Direct Mode.

[ 10 ] Pelco Manual C519M-D (7/00)