404 PLASTER RING INSTALLATION

NOTE: You should install the camera module into the back box before installing the back box into the cover. When installing the back box into the cover, rotate the camera module to access the mounting holes. Refer to Camera Module on page 14 for more information.

1.Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers to separate the cover from the back box.

2.Pull video and power wires into the cover. Use up to three supplied 6-32 x 0.75-inch Phillips pan head screws or two supplied 8-32 x 0.75-inch Phillips pan head screws to attach the cover to an installed 404 plaster ring. Use stainless steel hardware when installing the system outdoors.

3.Connect the video cable/wires:

BNC: Connect the BNC connector from the unit to a mating BNC connector.

Twisted Pair (UTP): Blue wire = Video +

Gray wire = Video -

4. Connect the power wires.

Voltage

Red Wire

Black Wire

12 VDC

+

Ground

24 VAC

~

~

AC operation only: If you are wiring more than one Camclosure integrated camera system to the same transformer, connect one side of the transformer to the red wire on all units, and connect the other side of the transformer to the black wire on all units. Failure to connect all of the units the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.

C3406M-D (1/07)

11

Page 11
Image 11
Pelco Not ICS110-CW manual Plaster Ring Installation, Twisted Pair UTP Blue wire = Video +, Voltage, Red Wire