Cover and Back Box Installation
The
UNSHIELDED TWISTED PAIR (UTP) VIDEO
The
At a minimum, UTP requires Cat5,
BASIC SURFACE INSTALLATION
NOTE: You should install the camera module into the back box before installing the back box into the cover. When installing the back box into the cover, rotate the camera module to access the mounting holes. Refer to Camera Module on page 14 for more information.
1.Remove the two
2.Using the cover as a template, mark one of the large holes on the mounting surface.
3.Cut out the hole for the power and video wiring.
4.Pull the video and power wires through the hole in the cover.
5.Attach the cover to the mounting surface (hardware not supplied). Use stainless steel hardware when installing the system outdoors.
6.Connect the video cable/wires:
BNC: Connect the BNC connector from the unit to a mating BNC connector.
Twisted Pair (UTP): Blue wire = Video +
Gray wire = Video -
7. Connect the power wires.
Voltage | Red Wire | Black Wire |
12 VDC | + | Ground |
24 VAC | ~ | ~ |
AC operation only: If you are wiring more than one Camclosure integrated camera system to the same transformer, connect one side of the transformer to the red wire on all units, and connect the other side of the transformer to the black wire on all units. Failure to connect all of the units the same way will cause the cameras to be out of phase with each other and may produce a vertical roll when switching between cameras.
8 |
