Pelco Not ICS110-CW manual Side Conduit Installation

5.Reinstall the back box inside the cover. For vandal-resistant installations, rotate the back box to position the conduit plug opposite the notch on the side of the cover. Use the two

8-32 x 0.375-inch Phillips pan head screws and washers (removed earlier) to secure the back box to the cover.

CEILING/

WALL

404 PLASTER RING

(NOT SUPPLIED)

COVER

6-32 X 0.75-INCH OR 8-32 X 0.75-INCH

PHILLIPS PAN

HEAD SCREWS (SUPPLIED)

BACK BOX

8-32 X 0.375-INCH PHILLIPS PAN HEAD SCREWS WITH WASHERS (SUPPLIED)

Figure 4. 404 Plaster Ring Installation

SIDE CONDUIT INSTALLATION

NOTE: You should install the camera module into the back box before installing the back box into the cover. When installing the back box into the cover, rotate the camera module to access the mounting holes. Refer to Camera Module on page 14 for more information.

1.Remove the two 8-32 x 0.375-inch Phillips pan head screws and washers to separate the cover from the back box.

2.Attach the cover to the mounting surface (hardware not supplied). Use stainless steel hardware when installing the system outdoors.

3.Remove the conduit plug from the side of the back box.

4.Use a blunt tool to pull the wires and plug, located on the base of the back box, into the back box.

5.Insert the black plug (supplied) into the hole in the base of the back box.

6.Reinstall the back box inside the cover. Line up the conduit plug with the notch on the side of the cover. Use the two 8-32 x 0.375-inch Phillips pan head screws and washers (removed earlier) to secure the back box to the cover.

12 C3406M-D (1/07)