Pelican PSE1800, PSE2000 Care and Cleaning, Premium Whole House Water Filter, Sediment Filter

Pelican PSE1800/PSE2000 Premium Whole House Water Filter	PSE1800-2000 Rev M
& Salt Free Water Softener/Conditioner Combo	Page 16

Care and Cleaning

Premium Whole House Water Filter

Your Pelican Premium Whole House Water Filter requires care and cleaning after a period of 5 years. Replacement media and instructions can be ordered on-line at www.pelicanwater.com or by calling 877- 842-1635.

Sediment Filter

It is recommended that the Sediment Filter be replaced every 6-9 months depending on the amount of sediment present in the water supply. If the system has been working properly and the pressure is slowing, it may be time to change the Sediment Filter. Check the Sediment Filter and replace if necessary.

Replacing the Sediment Filter

Pre-Filter Cover Sediment Filter

O-Ring

Blue Pre-Filter Housing

Stand Pipe

1.Turn off the main water supply to the Pre-Filter System and bypass all tanks.

2.Run a faucet (cold water) inside the house to relieve the pressure.

3.Unscrew the Blue Pre-Filter Housing clockwise using the supplied Pre-Filter Wrench.

4.Remove the existing Sediment Filter and discard.

5.Remove the O-Ring and wipe the groove and O-Ring clean. Lubricate the O-Ring with a coating of clean silicone grease. Replace O-Ring and press the O-Ring down into the groove with two fingers.

Note: This step is important to ensure the proper filter seal. Make sure the O-Ring is seated level in the groove. If the O-Ring appears damaged, stretched, or crimped it should be replaced at this time.

6.Place a new Sediment Filter onto the Stand Pipe in the Blue Pre-Filter Housing.

7.Screw the Blue Pre-Filter Housing onto the Pre-Filter Cover.

8.Turn on main water supply slowly to allow the Pre-Filter System to fill with water and put tanks back in service, out of bypass.

9.Check for leaks.

© 2013 Enviro Water Solutions, Inc.	www.pelicanwater.com
3060 Performance Circle, Suite 2, DeLand, FL 32724	(877) 842-1635