Pella 81DU0100 Integrating The Door To The Water Resistive Barrier, Head, ~ 8”, Flashing Tape

3SETTING AND FASTENING THE DOOR (continued):

P.Doors with a lock strike in the side (jamb) and without a sidelight on the lock side:

'ULOODQGLDPHWHU[GHHSSLORWKROHLQWRWKHURXJKRSHQLQJWKURXJKWKHSUHGULOOHG holes located in the frame as follows:

3Door Frame Corner:

Drill pilot holes through the pre-drilled hole located in the upper frame corner on the lock MDPEVLGHDSSUR[LPDWHO\IURPWKHWRSRIWKHGRRUIUDPHKHDG

3Doors with Multi-point Lock:

Drill through the one pre-drilled hole located in each lock strike. (Pull back frame weatherstrip to locate open hole in strike).

3Center Latch and Deadbolt Lock: 'ULOOWKURXJKWKHPRXQWLQJKROHORFDWLRQV,QVHUWD[VFUHZLQWRWKHSLORWKROHV making sure it passes through the shim and into the rough opening.

Note: This step does not apply to center latching double doors.

3P1O	Head
J	~ 8”
a
m
b

3P2 3P2

Pull back weatherstrip to expose strike hole.

O

3P3

4INTEGRATING THE DOOR TO THE WATER RESISTIVE BARRIER:

Note: The flashing tape must be applied approximately 1/2" onto the frame cladding at the jambs and head. Pre-folding the tape at 1/2" before removing the paper backing will make it easier to apply the tape correctly. If the siding is less than 1/2" thick, adjust the dimension of the fold so the exterior sealant line will cover the exterior edge of the tape.

Flashing

Tape

A. Apply side flashing tape. Cut two pieces of flashing WDSHORQJHUWKDQWKHIUDPHKHLJKWRIWKHGRRU $SSO\RQHSLHFHRQWRWKHIUDPHFODGGLQJRYHU the nailing fin and onto the water resistive barrier on HDFKVLGH7KHWDSHVKRXOGH[WHQGDERYHWKHWRS RIWKHGRRUDQGEHORZWKHERWWRPRIWKHGRRU Press the tape down firmly while folding down the H[FHVVWDSHDWWKHWRSDQGERWWRPRIWKHGRRU

4AÎ