Pella 81DU0100 Installation Clip Method, See C for Clip Application Details

5DOOR REPLACEMENT IN SIDING WITHOUT NAIL FIN (continued):

Frame Screw Method:

Note: If installing with installation clips, proceed to step P.

J.Jambs'ULOODQGFRXQWHUVLQNGLDPHWHUFOHDUDQFHKROHVWKURXJKWKHGRRUIUDPHRQO\ and not into the rough opening at the locations shown on the diagrams.

Note: Out-Swing Doors Only - If choosing to locate clearance holes through the frame to be concealed by door panel; remove frame weatherstrip and drill holes under the weatherstrip.

5J

K.Frame Head'ULOODQGFRXQWHUVLQNGLDPHWHUFOHDUDQFHKROHVWKURXJKWKHGRRU frame head only and not into the rough opening at the locations shown on the diagrams.

L.Threshold'ULOODQGFRXQWHUVLQNGLDPHWHUFOHDUDQFHKROHVWKURXJKWKHWKUHVKROG but not into the rough opening at the locations shown on the diagrams

0 Drill 1/8" x 1" deep pilot holes through the clearance holes and into the rough opening framing in the head, jambs and threshold of the unit frame.

N.Secure the jambs and head of the door.'ULYH[FRUURVLRQUHVLVWDQWZRRG screws through the door frame and shim, into the rough framing. Drive the screws until snug but DO NOT over-tighten the screws. DO NOT bend or bow the unit frame.

O.Secure the sillE\GULYLQJ[FRUURVLRQUHVLVWDQWZRRGVFUHZWKURXJKWKH WKUHVKROGLQWRWKHŶRRU)RUPDVRQU\DSSOLFDWLRQVXVHPDVRQU\VFUHZVDPLQLPXPRI GLDPHWHU[DQGSLORWGULOOSHUVFUHZPDQXIDFWXUHUőVUHFRPPHQGDWLRQV

Go back to 3H - 3P to complete fastening through hinges and strikes.

Installation Clip Method:

See Step 2C for Clip Application Details

P.Fasten the door to the opening by driving

WZR[FRUURVLRQUHVLVWDQWVFUHZV into the pre-punched holes in the clips.

If the clips are bent and fastened to the

interior stud/block, install the screws as 5PF close to the bend as possible.

Note: DO NOT shim above the door. For masonry openings use two masonry screws that are a minimum size of 3/16" x 1-1/2" per clip. Pre-drill the masonry per screw manufacturer’s recommendations before attempting to drive the screws in.

Go back to 3H - 3P to complete fastening through hinges and strikes.