1 ROUGH OPENING PREPARATION (continued): |
|
| ||
R. Cut a piece of flashing tape to the width of the opening. Install to the flanges of the sill | ||||
| SDQDQGRYHUODSWKHWDSHIURPVWHS1E\,IQHHGHGDGGDVHFRQGRUWKLUGSLHFHRI | |||
| flashing tape until the sill pan is covered to the interior sill pan lip. |
|
|
|
| Note: The purpose of this tape is to seal the sill screws when installing the door. |
| ||
S. | Cut two pieces of flashing tape |
|
|
|
| and apply to the bottom corners of the opening | 1S |
|
|
| by beginning in the corner of the sill pan, with |
| 1R | |
|
|
| ||
| RIWKHWDSHDSSOLHGWRWKHVLOOSDQDQG |
|
| LIP |
| RIWKHWDSHDSSOLHGWRWKHVLGHŶDQJH7KH |
|
| |
|
|
|
| |
| UHPDLQGHURIWKHWDSHLVWREHDWDGHJUHH | SILL | LIP |
|
|
|
| ||
| DQJOHRQWRWKHH[WHULRU |
|
| 1" |
|
|
|
| |
T. | Attach the aluminum sill support or wood |
|
|
|
| blockingWRWKHH[WHULRURIWKHER[SODWHWR | 1TP |
|
|
| support the edge of the door sill. Place the sill |
|
| |
|
|
|
| |
| support flush with the subfloor. |
|
|
|
|
| INTERIOR |
| |
|
|
| SILL |
|
|
|
| PAN | |
|
|
|
| LIP |
2PREPARE THE DOOR FOR INSTALLATION:
TWO OR MORE PEOPLE WILL BE REQUIRED TO HANDLE THE PANEL AND FRAME SAFELY.
A.Remove plastic wrap and cardboard packaging from door. Do not remove plastic shipping spacers. The shipping spacers will help keep the door square during installation. Do not open the door until it is fully fastened.
Note: If grilles or hardware are removed from the door at this time, label them and store them in a protected area.
B.For doors without EnduraClad® Brickmould: Fold out installation
ŵQWR r%HFDUHIXOQRWWR remove or tear the fin corners.
Note: If the fin corner is not at 90°, the door will not align correctly on the interior.
Note: The nail fin on doors with brickmould and nail fin will come from the factory folded up.
Ó |
Door with
Brickmould
C.Doors using Installation Clips: Install installation clips. Place each clip so the lip is facing up and against the installation fin at the locations shown in the placement diagram. Secure each clip
E\GULYLQJD[FRUURVLRQUHVLVWDQW screw through each of the outer two holes of the three holes shown.
Note: If clips are to be bent;
#6 x 5/8” corrosion resistant screws
Lip
2C
6“ from end
Note: Bending clips after attaching to frame will bow the frame.
