Pella 81DU0100 installation instructions SETTING AND FASTENING THE DOOR continued

3SETTING AND FASTENING THE DOOR (continued):

F.Check the interior reveal. 0DNHVXUH the measurement from the interior face of the door to the interior face of the

wall is equal at several points around	E
the door.	3F

Note: If dimensions are not equal, check to make sure the fins are folded out to 90° at all points.

Clip or Frame Screw Installation, go to Step 5I

mm	1	INCHES		2
20		30	40			3
				50	60
						70

3ED

Interior	3FE
3ED
	3ED

* Fasten the door WRRSHQLQJE\GULYLQJJDOYDQL]HGURRŵQJQDLOLQWRHDFKSUH punched hole in the nailing fin.

Note: Make sure the fin corner is lying as flat as possible

3G

H. Carefully open the door(s) and

remove all shipping spacers.

Note: Be sure to remove the spacers from the bottom edge of the door panel.

Double Doors with Multipoint latch in center: Use the construction handle to operate the active door handle. Operate the flushbolts per the instructions on the label on the strike located on the astragal.

I.Designer Series® Out-Swing: Install sill screws. Place a dab of sealant in each

RIWKHSUHGULOOHGKROHVLQWKHERWWRPRIWKHXQLWVLOO7KHQLQVHUWD[ FRUURVLRQUHVLVWDQWVFUHZSURYLGHGLQWRHDFKKROH)RUPDVRQU\ŶRRUVXVD PDVRQU\VFUHZLQSODFHRIWKHSURYLGHGVFUHZSLORWGULOOSHUVFUHZPDQXIDFWXUHUőV recommendations.

All other: Sill screws are not needed.

For combinations (Multi-wide): 3UHGULOOIUDPHDWPXOOLRQHQGV IURPHDFK PXOOLRQMRLQWDQGLQVHUW[FRUURVLRQUHVLVWDQWVFUHZV)RUPDVRQU\DSSOLFDWLRQV XVHPDVRQU\VFUHZV

J.For Low Profile Sills: 7KURXJKHDFKLQVWDOODWLRQVFUHZKROHGULOODSLORWDQGLQVWDOO D[FRUURVLRQUHVLVWDQWVFUHZSURYLGHGLQWRWKHSLORWKROHLQWRWKHŶRRU)RU doors including a standard lock install tubs per instruction included with the sill strike package.

Note: For concrete floors use masonry screws a minimum size of 3/16" diameter x 3" and pilot per manufacturer’s recommendations for the screw.