Williams Official Gas Heater Manual - P295200A, P295201A and Operating Instructions

FOR YOUR SAFETY, READ BEFORE LIGHTING

WILLIAMS GAS CONTROL VALVE P295200A & P295201A

IWARNING:may resultIf youcausingdo not propertyfollow thesedamage,instructionspersonal exactly,injury ora firelossorofexplosionlife.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell around the appliance area

for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance,

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

C,

O.

•If you cannot reach your gas supplier, call the fire department.

Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it, call a qualified serv-

ice technician. Force or attempted repair may result in a fire or explosion.

Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

OPERATING INSTRUCTIONS

1.STOP! Read the safety information above.

2.Set the thermostat to lowest setting.

3.Turn off all electric power to the appliance. (If applicable),

4.Remove control access panel.

5.Push in gas control knob slightly and turn

clockwiee/_ I to "OFF."

S. Find pilot--follow		metal tube	N
from gas	control.	The pilot is
mounted	on side	of burner.

9.Turn knob on gas control

counterclockwise _ to "PILOT."

GENERATORPILOT

BURNER

L_	_L_-L_	1 _	GAS	CONTROL
I	I _"/_'J_---'_		KNOB	SHOWN

POSITION

NOTE: Knob cannot be turned from "PILOT" to "OFF"

unless knob is pushed in slightly. Do not force.

6.Wait five (5) minutes to clear out any gas, then smell for gas, including near the floor. If you then smell gas, STOP! Follow "B" in the safety information above. If you don't smell gas, go to the next step.

7.Loosen wlngnut and open the pilot observation door (if equipped).

10.Push in control knob all the way and hold in. Immedi- ately light the pilot.

Continue to hold the control knob In for about one (1) minute after the pilot Is lit. Release knob and it will pop back up. Pilot should remain lit. If It goes out, repeat steps 5 through 10.

•If knob does not pop up when released, stop end

immediately call your service technician or gas supplier.

•If the pilot will not stay lit after several tries, turn the gas control knob to "OFF" and call your service technician or gas supplier.

11.Close pilot observation door, tighten wingnut (if equipped).

12.Turn gas control knob counterclockwise IP'_to "ON".

13.Close control access panel.

14."rum on all electric power to the appliance (if applicable).

15.Set thermostat to desired setting.

TO TURN OFF GAS TO APPLIANCE

1.Set the thermostat to lowest setting.

2.Turn off all electric power to the appliance if service is to be performed (if applicable).

3.Open control access panel.

4.From "ON" position, depress and turn gas control knob clockwise/_ to "OFF" position. Do not force.

5.Close control access panel.

WARNING: DUE TO HIGH SURFACE TEMPERATURES -- KEEP CHILDREN, CLOTHING, FURNITURE OR ANY COMBUSTIBLE MATERIAL AWAY FROM FURNACE.

IMPORTANT: KEEP BURNER AND CONTROL COMPARTMENT CLEAN.

--19--