I.Install screen by inserting the top of the screen into the screen pocket located at the exterior head of the patio door. Compress the top rollers just enough to allow the bottom of the screen to be inserted onto the bottom screen track. Adjust the screen rollers by turning the adjustment screw located at the top and bottom until the screen operates smoothly and is plumb and centered from top to bottom. Install the screen keeper if desired.
6 INTERIOR SEAL
Caution: Ensure use of low pressure polyurethane window and door insulating foams and strictly follow the foam manufacturer's recommendations for application. Use of high pressure foams or improper application of the foam may cause the door frame to bow and hinder operation.
A.Apply insulating foam sealant. From the interior, insert
the nozzle of the applicator approximately 1" deep into the space between the door and the rough opening and apply a 1" deep bead of foam. This will allow room for expansion of the foam and will minimize squeeze out. If using foam other than Great Stuff ™ Window and Door Insulating Foam Sealant by the Dow Chemical Company, allow the foam to cure completely (usually 8 to 24 hours) before proceeding to the next step.
Note: It may be necessary to squeeze the end of the tube |
| |
with pliers to be able to insert into the space between the |
| |
door frame and the rough opening. DO NOT completely |
| |
fill the space from the back of the fin to the interior face | È | |
of the door. | ||
|
B.On the interior, seal the door sill to the floor with a corner bead of sealant. Connect this bead of sealant to the insulating foam at both door jambs.
C.Check door operation by opening and closing the door.
Note: If the door does not operate correctly, check to make sure it is still plumb, level, square and that the sides are not bowed. If adjustments are required, remove the foam with a serrated knife. Adjust the shims, and reapply the insulating foam sealant.
7 SEALING THE DOOR TO THE EXTERIOR WALL CLADDING
Note: When applying siding, brick veneer or other exterior finish materials, leave adequate space between the door frame and the material for sealant. Refer to the illustration that corresponds to your finish material. Not allowing adequate space or not using backer rod may cause the sealant to break down prematurely and allow water to infiltrate.
BRICK VENEER |
Insulating |
Foam |
1/2" |
1/2" Min.
| VINYL/STEEL | WOOD SIDING |
| SIDING | |
| WITH TRIM | |
|
| |
Backer rod | Backer rod |
|
and | and | Backer rod |
sealant | sealant | and |
typical | typical | sealant |
Insulating | Insulating | typical |
Foam | Foam |
|
| 1/2" | 1/2" |
|
|
|
|
|
| 1/2" Min. |
1/2" Min. |
| |||
|
| |||
