Pentair Hot Tub manual Electrical, MiniMax CH Millivolt Wiring Diagram, Installation contd

Installation (contd.) 17

ELECTRICAL

MiniMax® CH Millivolt Wiring Diagram

MINIMAX® WIRING DIAGRAM (MILLIVOLT) DUAL THERM (HONEYWELL ELECTRONIC)

IF ORIGINAL FACTORY WIRING MUST BE REPLACED, INSTALLER MUST SUPPLY UL OR CSA (IF CANADA) APPROVED WIRE, 18 GAUGE, 600V, 105 C˚ TEMPERATURE RATING. THERMAL FUSE WIRING MUST BE REPLACED WITH UL OR CSA (IF CANADA) APPROVED WIRE, 18 GAUGE, 600V, 125 C˚ TEMPERATURE RATING. INTERCONNECTING WIRING TO APPLIANCE MUST CONFORM TO THE NATIONAL ELECTRICAL CODE OR SUPERCEDING LOCAL (WIRING) CODES.

		PILOT
TH/PP	WHT	GENERATOR
	RED
TH	PP		SAFETY	PRESS
GAS VALVE
		HI-LIMIT	SHUT-OFF	SWITCH
WHT		WHT	WHT	WHT

THERMAL

CUT-OFF

ORN

WHT

WHT

TH/PP

PP TH

POT 1 POT 2

THERMOSTAT BOARD

SEN	POT
	SENSOR

POOL

OFF

SPA

Figure 19.

NOTE: When connecting a remote control to the MiniMax® CH, you must install the low voltage thermostat wires in separate conduit from ANY line voltage wires. Failure to follow these instructions will cause the thermostat relay to react erratically.

Rev. E 11-5-07 P/N 472128