Pentair LX-100EZ owner manual Valve Actuators, Receiver Antenna

VALVE ACTUATORS

Remove knob, handle and four screws from cap of valve(s) to be motorized, and use the four mounting screws provided to mount Valve Actuator(s) to valve(s).

Run cables to low-voltage wiring compartment of LX-100 RF Power/Load Center, and plug into circuit board at the appropriate Valve Socket:

Plug intake (suction) valve into INT VLV Socket. Plug return valve into RET VLV Socket.

Plug auxiliary valve (if applicable) into AUX VLV Socket.

COMPOOL	CLNR TIMER FLTR TIMER
11056
PART#:PC-LX100
	MOTOR SWITCH MOTOR SWITCH	18 24	0

LX-100 RF POWER/LOAD CENTER

INTAKE	RETURN	AUXILIARY
VALVE	VALVE	VALVE
ACTUATOR	ACTUATOR	ACTUATOR

INT

VLV

RET

VLV

AUX

VLV

RECEIVER ANTENNA

CAUTION

Antenna must be attached with o-ring for proper functioning. Not installing o-ring can lead to damage of LX-100 RF Power/Load Center.

Slide orange o-ring over threaded antenna connector protruding from top of the

LX-100 RF Power/Load Center.

Screw on antenna until it stops. O-ring should be compressed by antenna.

ENCLOSURE

P/N 520050 12 Rev. F 3-26-04