Powering the Camera

1 GettingStarted

Installing the Batteries

Install the batteries into the camera. Use two AA alkaline, AA lithium, AA Ni-MH, or AA nickel manganese batteries.

1 Open the battery/card cover.

Slide the battery/card cover in the direction 1. The cover will automatically open in the direction 2when you release your fingers from it.

2 Insert the batteries, making sure the (+) and (–) terminals on the batteries match the (+) and (–) symbols inside the battery compartment.

3 Close the battery/card cover and slide it in the opposite direction of 1.

•AA alkaline, AA lithium and AA nickel manganese batteries are not rechargeable.

•Do not open the battery/card cover or remove the batteries while the camera is turned on.

•If you do not intend to use the camera for a long time, remove the batteries. If the batteries are left in the camera for a long time, they may leak.

•If the batteries have been removed from the camera for a long time, when they are reinserted and the camera is turned on, the message [Battery depleted] may appear. This can also happen when using the camera for the first time; however this is not a malfunction. Turn the camera off, wait a minute and then turn the camera on again to reset the camera. The date and time may also be reset.

•Insert the batteries correctly. If the batteries are incorrectly oriented, malfunction may result. If the ends of the batteries look dirty, wipe them before inserting into the camera.

19