The following diagram is an illustration of the operation of this feature.

(A)– Remote Media Converter setup for Fiber Fault Alert Enabled, Fiber Negotiation – OFF and Link Mode – Standard.

(B)– Local Media Converter setup for Fiber Fault Alert -Enabled, Smart Link Pass-Through - Enabled and Fiber Negotiation - OFF

(A) Loses fiber connection on its receiver.

(A)Disables fiber transmitter.

(B)Detects loss of link on its fiber receiver.

(B)Drops link on copper connection because Smart Link Pass- Through is configured.

(A)Link on copper connection is not affected because Smart Link Mode is set to Standard.

Duplex copper (Switch 4)

Switch Position

Mode

 

 

Up (default)

Full

 

 

Down

Half

 

 

Note: When Auto Negotiation (SW1) is set to Off, the Media Converter will use this Duplex setting for its copper connection.

Up: The Media Converter Module will be set to Full Duplex mode.

Down: The Media Converter Module will be set to Half Duplex mode.

8

Perle 10/100/1000 Media Converter Module – Instal lation Guide

Page 8
Image 8
Perle Systems c-1111-xxxxx manual Duplex copper Switch