Installation and Tapping – Beer Dispensers
Connecting the Keg Coupler
(when Supplied by Perlick)
■ | Place one brown leather washer into black beer |
| line connector hose on hex nut side. Screw |
| connector to stainless steel beverage line on |
| faucet standard. Tighten with a wrench, but do |
| not over tighten. |
■ | Make sure lever handle on the keg coupler is in |
| the UP (untapped) position. Place one brown |
| leather washer into wing nut end of black beer |
| line connector hose and thread onto top of keg |
| coupler. Hand tighten. |
■ | Place clamp on one end of red air line. Push |
| end over air valve located inside cabinet. |
| Tighten clamp with screwdriver. Turn |
| valve to OFF (horizontal) position. |
Connecting the Regulator to the CO2 Cylinder
■Remove blue plug from regulator fitting. (Note: Do not remove the carbonic washer).
■Screw regulator onto gas cylinder valve. Tighten with wrench until vertically straight. Be sure that
■Place a screw clamp over end of red air line and push onto regulator tailpiece. Tighten clamp with a screwdriver.
REGULATOR | HAND |
FITTING | |
CO2 | VALVE |
PRESSURE |
|
GAUGE |
|
30
20 40
PERLICK |
1050
■ Place clamp on the other end of red air line and |
push over tailpiece on coupler. Tighten clamp |
with screwdriver. |
CAUTION: Do not use keg coupler as a |
handle to lift keg. |
Tapping a Single Valve Keg (Sankey):
PSI
0
FITTING FOR RED AIR HOSE
60
CO2
GAS
DRUM
REGULATOR
ADJUSTING
Step 1
Single Valve Keg Coupler
Step 3
Step 2
■Be sure beer faucet is in closed position.
■Align keg lugs with lug openings on bottom of coupler.
■Turn clockwise 1⁄4 turn. Pull handle out and down. Keg is now tapped.
■Open
Important: Be sure to close this valve when untapping keg.
CLOSED POSITION)
Adjusting the CO2 Gas Flow
■Turn regulator adjusting screw counterclockwise until it turns freely.
■Turn hand valve counterclockwise on CO2 cylinder to the fully open position.
■Turn regulator adjusting screw clockwise until desired pressure is reached (approximately
■Open
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice.
6