Pertech A470 manual Configuring the Printer, Dip Switch a Dip Switch B

A470 Users Guide

Configuring the Printer

To change the configuration settings two banks of dip switches are located on the bot- tom of the printer. On the Self Test & Configuration Report printout you can see the dip switch configuration for both banks. Below is a table that defines what each dip switch controls. Cycle power for dip switch changes to take effect.

ON = C = CLOSED

1 2 3 4 5 6 7 8

OFF = O = OPEN

1 2 3 4 5 6 7 8

A7

A8

Dip Switch “A”						Dip Switch “B”
	Interface					Pitch / Chars. Per Line
	Switch		A-1	A-2	A-3	Switch	B-1	B-2	B-3
	19.2k Baud		O	O	O	12.0/33	O	O	O
	9600 Baud		O	O	C	13.1/36	O	O	C
	4800 Baud		O	C	O	14.4/40	O	C	O
	2400 Baud		O	C	C	16.0/44	O	C	C
	1200 Baud		C	O	O	18.0/50	C	O	O
	600 Baud		C	O	C	20.6/57	C	O	C
	300 Baud		C	C	O	24.0/66	C	C	O
	Parallel		C	C	C	Not Used	C	C	C
	Journal Line Feed					Character Set
	Switch		A-4	A-5		Switch	B-4	B-5	B-6
	5.3 Lpi		O	O		Usa	O	O	O
	6.0 Lpi		O	C		Uk	O	O	C
	6.9 Lpi		C	O		German	O	C	O
8.0			C	C		French	O	C	C
						Italian	C	O	O
	Auto Line Feed					Spanish	C	O	C
	Switch			A-6		Hebrew	C	C	O
	On	<CR>is<LF>		O		Not Used	C	C	C
	Off	<CR>is<CR>		C		Validtion Clamp
	Serial Handshake (RS-232 I/F Selected) Switch						B-7
	Switch			A-7		Closed	O
	RTS			O		Open	C
	XON / XOFF			C		Serial Data Format
	Pin 13 Select		(Parallel I/F		Selected)
	Switch			A-7		Switch	B-8
	Form In			O		8 Bits	O
	Select Line			C		7 Bits	C
	RTS Polarity (RS-232 I/F Selected)
	Switch			A-8
	-12v (Mark)			O
	+12v (Space)			C
	Fault On Low Paper (Parallel I/F Selected)
	Switch			A-8
	Yes			O
	No			C

Pertech® 2006 13