www.petsafe.net 7
4) Remove the lter housing by gently pushing in on either side of
the fountain where the curve meets the seam. Gently lift up. (See
Fig. 2b & 2c)
Fig. 2b Fig. 2c
NOTE: You will notice the right side of the housing will offer some
resistance as the water intake tube pulls away from the motor.
5) Next, remove the motor (Fig. 2d) by rst disconnecting the inline
plug (Fig. 2e), then lift it out of the fountain. Clean away any hair
or kibble that may have accumulated around the ow control
knob and the intake plate of the pump.
Fig. 2d Fig. 2e
Clean the fountain parts with warm water and soap. You can also
put the fountain in the top rack of the dishwasher. Remove the
pump before placing the fountain in the dishwasher. If possible, it
is recommended that you turn down the heat of the water inside
the dishwasher.
If you have troubles reaching certain spots or getting
hard-to-reach corners, try using a cotton swab or set of bottle
brushes (Drinkwell® 3-Brush Cleaning Kit available).
Once the fountain is completely disassembled you will have:
4 plastic parts and the motor.
6)
7)
8)