Installation and commissioning
8.05 Basic position of the machine drive unit
8.05.01 On machines with PicoDrive and control unit P41 PD2
●Switch on the machine.
●Call up the parameter input by pressing the "scroll" key.
●To switch the function keys to input (LED in the TE key lights up), press the TE key.
●By pressing the corresponding +/- keys, select parameter "798" and service level C, see Chapter Selecting the User Level in the separate Control Panel Instruction Manual.
●Select parameter "799" by pressing the corresponding +/- keys.
●Check whether the value is set at "2" and alter if necessary.
●Switch the machine off and then on again.
●Select parameter "800" by pressing the corresponding +/- keys.
●Check whether the value is set at "0" (balance wheel turns towards the operator) and alter if necessary.
●Select parameter "802" by pressing the corresponding +/- keys.
●Check whether the value is set at "0" (= no reduction ratio) and alter if necessary.
●.By pressing the corresponding +/- key, select parameter "700"
●Sew a stitch by operating the pedal.
●Turn the balance wheel in the sewing direction until the descending needle is level with the top edge of the needle plate.
●Conclude the adjustment of the sewing motor by pressing the "scroll" key
8.05.02
A 
B 
S
A
A 
B 
S
D
S
With drive system
●Press and hold button and switch on machine
●Parameter 176 is displayed.
●Call up parameter 181.
●Call up input level.
●Sew a stitch with the pedal function.
●Turn the handwheel in rotational direction until the needle point (approaching from above) is on the upper edge of the needle plate.
●Confirm entry.
●Call up parameter 192.
Call up input level.
Press button D+ to turn function "off". Press button "S" to exit input.
23