9. Maintenance
Caution!
–For cooling purposes the lamp is open. When removing the lamp do not tilt. If the inner tube is broken glass particles may fall out.
–Be very careful. The lamp and lampholder may still be too hot to touch.
–Keep lamp holder opening to your right. Do not touch lamp or point lamp holder opening at anyone.
–A
8.Carefully remove the new lamp housing from its package. Do not touch lamp or point lamp housing opening at anyone. Do not drop, as the impact may cause the lamp to break.
9.Place the lamp holder in the guiding slots and insert into the lamp compartment.
Resetting the lamplife time
1.Press Menu.
–The menu bar appears on the screen.
2. Use cursor control to |
|
|
|
| |
select Settings in the | Display | Picture | Audio | Settings | |
menu bar. | |||||
|
|
|
|
Language
Keystone correction
Feedback
Lamp counter
Key lock
Factory reset
3.Use cursor control to select Lamp counter in the sub menu.
Display Picture Audio Settings
Language
Keystone correction
Feedback
Lamp counter
Key lock
Factory reset
Lamp counter
0 hours
Lamp counter shows the operating hours of the lamp. It is suggested to reset when a new lamp is inserted. To reset keep confirmation key pressed for 3 seconds.
10.Tighten the screws.
11.Replace the cover and tighten the screws.
12.Plug the projector back in by inserting the mains lead in the Power socket.
13.Press the Stand by On button to switch on the projector.
14.Reset the lamp life time (see ‘Resetting the lamplife time’).
15.Properly dispose of the old lamp.
Notes:
–When replacing the lamp, always use the same type of lamp LCA3111/00, 12NC 8670 931 11009).
–Please dispose of lamp in special chemical disposal bins.
4.Press OK
5.If required, select another item you wish to adjust or press Menu to exit.
22
