Philips 201B user manual Troubleshooting, Common Problems, Having this problem?, Check these items

Troubleshooting

Troubleshooting

Safety Precautions and Maintenance • Troubleshooting • Regulatory Information • Other Related Information

Common Problems

Having trouble? Something not working? Before calling for help, try these suggestions.

Having this problem?

No Picture (Power LED not lit)

The screen says "NO

SIGNAL INPUT FROM INPUT A (or B)"

The screen says "NO

SIGNAL INPUT"

The screen says

"FREQUENCY IS OUT OF RANGE"

No Picture

(Power LED is amber or yellow)

Check these items

●Make sure the Power cable is plugged into the power outlet and back of the monitor.

●Power button of the monitor should be in the ON position.

●Disconnect the monitor from the power outlet for about one minute, then re-connect the power outlet again.

●Make sure the computer is turned on.

●Make sure the monitor cable is properly connected to your computer.

●Press OK and UP knobs on front control panel simultaneous to switch the Input Signal A/B.

●Check to see if the monitor cable has bent pins.

●Make sure the computer is turned on.

●Make sure the monitor cable is properly connected to your computer.

●Check to see if the monitor cable has bent pins.

●Change the settings of resolution and/or refresh rate of your computer. Refer to the Quick Start Guide or contact your computer vender for details.

●The Energy Saving feature may be activated. Drag your mouse or click any keypad on your keyboard to exit Energy Saving mode.

●Make sure the computer is turned on.

●Make sure the monitor cable is properly connected to your computer.

●Check to see if the monitor cable has bent pins.

●Press OK and UP knobs on front control panel simultaneous to switch the Input Signal A/B. (not for all monitors)

file:///D/rita/LF2/LF2/LFa1/multi_manual/english/201B/SAFETY/saf_troub.htm (1 of 3) [8/29/2001 3:12:02 PM]