[Pixel Plus Link]: Overrides the settings of connected devices and uses the settings of the TV. (Available only when you activate Easylink).
3 Press | to select your preference. |
4Press OK.
5Press EXIT to exit.
Access decoder channel
You can map channels provided through a decoder or descrambler to your TV channel selection. In this way, you can select these channels by using the RC of your TV.The decoder or a descrambler must be connected to EXT1 (SCART).
Set decoder channel
Map channels from a decoder or descrambler.
1Press MENU.
2Select [Setup] > [Installation] > [Decoder].
3Press to enter [Decoder] menu.
4Press to select [Channel], then press
to enter.
5Select one channel to map to the decoder / descrambler channel and press
OK
6Select [Status], then press to enter.
7Select [EXT 1] (SCART) the connector used by the decoder / descrambler.
8Press OK.
9Press EXIT to exit.
Note
Select [None] if you do not want to map to the decoder / descrambler channel.
Start a TV demo
You can use demonstrations to better | English |
| |
understand the features of your TV. Some |
|
demos are not available on certain models. |
|
Available demos are displayed in the menu list. |
|
Note
Before starting, make sure to turn PBS mode off for TV Demo to take effect:
1Press MENU.
2Select [Setup] > [Features] > [Demo].
3 Press to enter [Demo].
4 Press to select a demo and press OK to view it.
5Press EXIT to exit.
Reset the TV to factory settings
You can restore the default picture and sound settings of your TV.The channel installation settings remain the same.
1Press MENU.
2Select [Setup] > [Installation] > [Factory settings].
3 Press to enter [Factory settings].
4Select [Reset] to start resetting.
5Press OK.
6Press EXIT to exit.
EN 27