Philips Onis 300 Vox manual Installing the base station, Installing and replacing the batteries

Models: 300

1 33
Download 33 pages 22 Kb
Page 6
Image 6
Installing the base station

Conformity, Environment and Safety

Safety information :This equipment is not designed to make emergency calls when the power fails. An alternative has to be made available to allow emergency calls.

Conformity : See back cover page. In case you need a copy of the original certificate please contact the customer service centre.This product can only be connected to the analogue telephone network in the area which is indicated on the label placed on the packaging.

Power requirements : This product requires an electrical supply of 220-240 volts, alternating monophased power, excluding IT installations defined in standard EN 60-950.

Warning ! The electrical network is classified as dangerous according to criteria in the standard EN 60-

950.The only way to power down this product is to unplug the power supply from the electrical outlet. Ensure the electrical outlet is located close to the apparatus and is always easily accessible. Telephone connection : The voltage on the network is classified as TNV-3 (Telecommunication Network Voltages, as defined in the standard EN 60-950).

Safety precautions : Do not allow the handset to come into contact with water. Do not open the handset or the base station.You could be exposed to high voltages. Do not allow the charging contacts or the battery to come into contact with conductive materials. (1).

Environmental care : Please remember to observe the local regulations regarding the disposal of your packaging materials, exhausted batteries and old phone and where possible promote their recycling.

Installing the base station

To properly install the base station, plug the line cord and the power cable into the base station. Plug the cord and the cable into the wall.The green indicator on the base station and a beep indicate that the phone is properly installed.

!Warning : Always use the cables provided with the product.

(1) Do not insert anything in this opening.

Installing and replacing the batteries Installing and replacing the batteries

To insert the batteries, open the battery cover, place the batteries as indicated and put the battery cover back.When the handset is placed on the base station the 3 battery bars scroll (if charge is needed). Allow the handset to charge for 24 hours to reach full charge. On first use it may be necessary to wait for a few minutes before seeing symbols on the display. In case you need to change the batteries, the following type is mandatory R03/AAA NiMh 600/650 mAh.

Warning :The base station must always be plugged into the mains when charging. Always use rechargeable batteries.

Battery life and range

Batteries should not be disposed of with general household waste.

 

The battery life is about 250 hours in stand by time (when the handset is in idle mode & ready to receive a call) and around 16 hours in communication. A battery low alert will inform you that the handset has to be recharged, if this is during a call, the call will end shortly after the alert.

Optimal battery life is reached after 3 cycles of full charge/discharge.

Under ideal conditions the range is a maximum of 50 metres indoors and 300 metres outdoors.When reaching the range limit, the conversation will become crackly, move closer to the base station otherwise the call will be cut off.To reach optimal range place the base station away from electrical appliances.

4

Conformity, Environment & Safety

Page 6
Image 6
Philips Onis 300 Vox manual Installing the base station, Installing and replacing the batteries, Battery life and range